Trainee Name____________________________

Trainee Social Security Number: ____________

Trainee Status:  _______

Course Name: ___________________

Course Code: ___________________                                 

National Center Course Number: __________

Date Course Completed: ____________________

Performance Criteria Completed:  ____________

Performance Objectives:

                                                                                                                    Pass     Fail                  

Topic 1: Preliminary Steps

1.1  Using the manufacturer’s manual and other information,
assemble the necessary tools and materials for the overhaul
of a centrifugal pump.

1.2  Describe safety precautions that should be taken when work
is done on a centrifugal pump.

1.3  Remove the upper half of the casing of a horizontally split
centrifugal pump.

1.4  Perform a preliminary inspection on the internal parts of a
Centrifugal pump.

Topic 2: Disassembly & Inspection 

2.1 Disassemble the internal parts of a centrifugal pump.

2.2 Inspect the parts of a centrifugal pump.

2.3 Make the measurements and calculations to determine the
      clearance between a casing wearing ring and an impeller.

2.4 Make the measurements to determine if a casing wearing ring
      is out of round.

2.5 Perform a runout test on a pump shaft.

Topic 3: Reassembly 

3.1 Install an impeller on a pump shaft.

3.2 Assemble a rotor and install the assembly in a centrifugal
      pump casing.

3.3 Assemble the casing of a centrifugal pump after the rotor
      has been installed.

Performance Evaluator’s Signature _______________________________

Performance Evaluator’s Name (Print) ____________________________

Date Completed: _____________________________________________